EZSplice® Belt Splicing Instructions

pdfDownload PDF Version
TOOLS REQUIRED:
  • Safety Glasses
  • EZSplice Strand
  • EZSplice Profiling Pliers

 

STEP 1.


 
Diagram A
Diagram A
Place the EZSplice strand between the two ends of the belt to be joined, matching and aligning the spaces of the strand with the spaces of the belt. Make sure that the cut end of the EZSplice strand is on the bottom. See Diagram A.
 

 

The cut end of the EZSplice strand must be on the bottom

 

STEP 2.

 

 
Turn the strand over
Turn the strand over
Once both ends of the belt are aligned with the spaces in the EZSplice strand, turn the EZSplice strand over and hook both end loops in as shown below.
   


Hook end loop in place.
   

Repeat opposite end.

 

STEP 3.

 

 
EZSplice with both endloops hooked.
EZSplice with both endloops hooked.
   
Turn EZSplice 180º


Turn EZSplice 180º
   

Turn and insert the second space of the EZSplice through the second space of the belt to be spliced and repeat every other space until the end of the belt is reached.
   
Now the bottom half of the joint is completed. Now the bottom half of the joint is completed.

 

STEP 4.

 

 


Once the bottom half is all locked into the appropriate spaces across the width of the belt, turn the EZSplice strand about 1/4 turn or about 90º up as shown to the left.
   

Hook the first space over.

Take the top half of belt and hook the first space over and through the first space of the EZSplice.
   
Repeat every other space till the end is reached.
Repeat every other space until the end of the belt is reached.
   
Now the splice is all in place Now that the splice is all in place, you are ready to "lock" your EZSplice strand into place with the EZSplice Profiling Pliers.

 

STEP 5.

 

* * * *
Match bit number to the belt mesh to be spliced

 

Insert the beveled edge of the bit into the jaw slot pushing in with your finger until you hear a click indicating that the bit is locked in place. Make sure to use the correct bit.


 

STEP 6.

 

* * * *
Repeat every other space till the end is reached.

 

Start in the center of the belt to be crimped, insert the lower jaw of the profiling pliers into the splice strand. Match the splice Z- bend up with the corresponding groove on the lower jaw of the profiling pliers and crimp down. Moving outward insert the lower jaw into the next splicing bend again matching the splice Z-bend up with the corresponding groove on the lower jaw into the next splicing bend again matching the splice Z-bend up with the corresponding groove on the lower jaw of the profiling pliers and crimp down. Repeat until the end of the belt is reached.